BDF water tank is made of BDF panel, BDF panel is a new material which is made of stainless steel and galvanized steel, inner side of the panel is stainless steel panel, outer side of the panel is galvanized steel panel, without welding, bolt connection, The thickness of stainless steel panel is 0.35mm for all BDF water tank panel, the remaining thickness is galvanized steel panel. It is suitable for drinking water, living water, fire water and Industrial water storage facilities, etc.
It looks like galvanized steel water tank outside, but the inner side is the stainless steel water tank. It has the advantages of the staniless steel water tank, but the price is cheaper than stainless steel water tank, because of the layer of galvanized steel panel.
Advantages: light weight, no corrosion, no leakage, good water quality, wide application range, long service life, good thermal insulation performance, beautiful appearance, convenient installation, convenient cleaning and maintenance, and strong adaptability
The following image show the sectional drawing of the BDF water tank panel to you.
The size of BDF water tank panel as follows:
1000x1000mm, 1000x500mm, 500x500mm
the thinckness or the panel as follows:
2mm, 3mm, 3.5mm, 4mm, 4.5mm, 5mm etc.
The water tank can be assembled with the size 0.125m³~2,000m³, depend on your requirement.
Packing: pallet or carton, it is convenient to load them into containers by forklift.
BDF water tank installation instruction:
1.The concrete foundation should be same level and the height should more than 500mm for checking.
2.Put the channel base on the concrete foundation, and ensure that the channel base is horizontal.
3.Assemble the bottom panel, ensure the connection method between panel and panel as follows: bolt--gasket--panel--rubber strip--another panel--gasket-nut, then tightening the bolt.
4.Assemble the side panel, ensure the connection method as same as the above-metioned. If reinforcement is required, the side panels need to be added auxiliary angle iron.
5.When we assemble the panel which has 45º slant bolt holes, we must loose three nuts of two side panels, then tighten 45º slant bolts, and then tighten the two side of loosing bolts.
6.Assemble the plugging, push out the plugging and add sealing gasket, angle iron, gasket and nut, then tighten the nut, glass glue.
7.Assemble the lacing bar, ensure that the lacing bar is not too tight or too loose.
8.Assemble the top cover panel.
9.Assemble the flange, ensure sealing well.
10.Assemble the ladder, ensure it is nearby the manhole.
The BDF water tank is your best choice. If you need a BDF water tank, do not hesitate, contact us at once.